Machsupport Forum

G-Code, CAD, and CAM => G-Code, CAD, and CAM discussions => Topic started by: Tdfox60 on May 18, 2009, 10:52:28 AM

Title: Radius to end of arc issue
Post by: Tdfox60 on May 18, 2009, 10:52:28 AM

Newbie here.  I am setting up to run my table top router for the first time using Mach 3.  I loaded my first G-Code and I am not able to get the program to run.  I am getting a message that reads "Radius to end of Arc differs from radius to startline 23"

Can someone please help this newbie out?

Title: Re: Radius to end of arc issue
Post by: ger21 on May 18, 2009, 10:54:08 AM

Change the IJ mode in General Config.

Title: Re: Radius to end of arc issue
Post by: electraflyit on August 21, 2009, 08:45:01 AM

I'm having the same problem.
I don't understand what mode to change in config.
Eddie

Title: Re: Radius to end of arc issue
Post by: Chip on August 21, 2009, 02:42:04 PM

Hi, Eddie

This is probilly what you need to change or put a G90.1 or G91.1 in the top of your G code file.

Hope this helps, Chip

Title: Re: Radius to end of arc issue
Post by: RICH on August 21, 2009, 05:58:59 PM

Try taking a look at the ACR Motion wirte up in Members Docs. It's for a Lathe but it covers a lot on arc's info.
RICH