Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: richyrich212 on May 13, 2009, 08:27:48 PM

Title: mach 3 and thc 300 arc voltage setpoint
Post by: richyrich212 on May 13, 2009, 08:27:48 PM

Hi all,


I have a plasma table running mach3 and the thc300 plugin.

Where is the proper location to set the arc voltage setpoint?? I have tried the
"tip volts" point under the settings page with no success. Does anyone know if this is the correct location to set your tip voltage ??

I am tried to trouble shoot if this is a THC issue or a Mach issue


thanks for any input in advance