Machsupport Forum

Mach Discussion => FAQs => Topic started by: Jens H on April 22, 2009, 08:06:27 AM

Title: Feed rate on start up.
Post by: Jens H on April 22, 2009, 08:06:27 AM

When I start mach3 the Feed rate is 6 (6mm/min--very slooow)
When i JOG this feed rate is used. I can change it, but next time i start Mach3 it is 6 again. Where can I change this value so it's default?

Title: Re: Feed rate on start up.
Post by: Greolt on April 22, 2009, 09:46:30 AM

Put it in the initialisation string in general config

F1000 for example.

Greg

Title: Re: Feed rate on start up.
Post by: Jens H on April 23, 2009, 02:58:28 AM

Thanks. That do the trick.