Machsupport Forum

Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: Aaronp on August 02, 2006, 10:35:48 PM

Title: Servo Dynamics
Post by: Aaronp on August 02, 2006, 10:35:48 PM

Has anybody interfaced servo dynamics amps to mach 3 or 4?

The amps that I can get free of charge require a 10+ to 10- volt DC input to control rotation.

I was wondering what hardware and such people were using?

Thanks
aaron

Title: Re: Servo Dynamics
Post by: cjmerlin on August 03, 2006, 05:49:41 PM

If you are into electronics What you will need is an 8 bit up/down counter connected to the step and direction outputs of mach3
and the same for your encoder then both 8bit outputs from the counters are fed to an 8 bit adder. This will give you the error signal in digital form. You will then need to convert the 8 bit error output from the adder to analouge with an A to D converter with an output offset to give the +10-10 command signal.

It might be worth having a chat with the guys at CNC4PC as they do some converter boards and I would have thought that a frontend for these old drivers would be ideal for a retrofit.


Regards
CJ

Title: Re: Servo Dynamics
Post by: Jaime on January 30, 2007, 03:15:01 PM

follow this link, this is the pixie 100,
  In: pulse/dir
out: +/-10 V

http://www.skyko.com/products/