Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Hairball on April 05, 2009, 11:22:18 AM

Title: Feedrate Overides in Lathe
Post by: Hairball on April 05, 2009, 11:22:18 AM
I can't seem to get the feedrates to overide, plus or minus, in Mach 3 Lathe (Version R3.042.020) while machine is cutting. I searched here and
messed with OEM codes and Gen config stuff as suggested but no luck?

Danny
Title: Re: Feedrate Overides in Lathe
Post by: Chip on April 07, 2009, 12:23:58 AM
Hi, Danny

I use a Modified Mach3mill.set (screen set) and changed the .set to Lset file type all the over-rides work just fine.

Chip
Title: Re: Feedrate Overides in Lathe
Post by: Hairball on April 07, 2009, 09:05:21 AM
Hi Chip,

Could you attach the modified mill.set to email or here?

Thanks  Danny
Title: Re: Feedrate Overides in Lathe
Post by: Chip on April 07, 2009, 12:45:32 PM
Hi, Danny

Hears the Lathe. lset file, Install it in C:Mach3 folder, It's a work in progress screen Lset.

You need also install the Zip file (JPG's) in C:\Mach3\Bitmaps\MillBitmaps folder.

Edit: New 1024 CHIP LATHE D1ACC.set some added items.

Have Fun, Chip
Title: Re: Feedrate Overides in Lathe
Post by: Hood on April 07, 2009, 06:25:16 PM
I too use a modified version of my mill screen as I never liked the Standard turn one, however I was testing for someone a week or two ago and FRO was working fine for me on the standard screen.
 If Chips doesnt sort you out attach your xml and I will have a look see if I can find a problem.
Hood
Title: Re: Feedrate Overides in Lathe
Post by: Chip on April 09, 2009, 11:04:02 PM
Hi, Danny

Did you get things working, Just updated/cleaned up the lathe.set a bit Above, Let us know.

Chip
Title: Re: Feedrate Overides in Lathe
Post by: Hairball on April 10, 2009, 11:02:53 AM
HI Guys,
Sorry about not answering sooner. I used your modified .lset and it is working just fine, thanks so much.
I also just renamed a mill.set to mill.lset and it works good also
Thanks for helping out as you always do...

Danny