Machsupport Forum

Third party software and hardware support forums. => Modbus => Topic started by: tubular2000 on March 31, 2009, 04:09:20 PM

Title: Click
Post by: tubular2000 on March 31, 2009, 04:09:20 PM

i had to buy a click plc to install on a project. since i had it on hand, i tried it with mach. it doesn't seem to be compatible with the modbus plug-in. maybe it is just a configuration problem. if anyone have success with this small plc, let me know. i would like to use it to control my i/o other then step and dir signal has a plc is much more reliable then any break out board.

Title: Re: Click
Post by: zarzul on April 14, 2009, 02:27:26 PM

Pretty impressive PLC especially for the price.  It looks like it should work with Mach, lot of ways to configure it.

Arnie