Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: keithmech on February 15, 2009, 06:09:11 PM

Title: motor tuning
Post by: keithmech on February 15, 2009, 06:09:11 PM

well this is not really about tuning but I reinstalled mach 3 when I
added a ss to my lathe.Now there is nothing when I try to do the motor tuning.
ie  conifg-motor tuning- nothing pops up?
Why?

Title: Re: motor tuning
Post by: HimyKabibble on February 15, 2009, 06:21:35 PM

Try re-installing Mach, but don't install the SS plug in.  Does it work then?

Sounds like Mach just didn't install properly.  What version are you using?

Regards,
Ray L.

Title: Re: motor tuning
Post by: keithmech on February 15, 2009, 08:23:30 PM

well I had tried a couple of instal/uninstalls but nothing, thats why I posted.
But i guess I must of stood just right because the last time was the one to make it work.