Machsupport Forum

Mach Discussion => FAQs => Topic started by: mattsaloeltjen on February 15, 2009, 03:58:14 PM

Title: mach stops after a while
Post by: mattsaloeltjen on February 15, 2009, 03:58:14 PM
I have a rather large file and after about 5 min of operation it stops and just sits there.  Is this because I have the demo version?
I know it has restrictions but I figured it would tell me why it stooped?
The file is a 3d face so it is big.
Title: Re: mach stops after a while
Post by: Sam on February 15, 2009, 05:01:40 PM
The demo is limited to 500 lines of code I believe. Most likely, that is indeed why it stopped.