Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Mr.Chips on January 01, 2009, 03:44:34 PM

Title: Mach3 View Screen too BIG for my monitor
Post by: Mr.Chips on January 01, 2009, 03:44:34 PM

When I started Mach3 Mill this morning the Mach3 screen was about 30% too large for my 17" monitor.  For some reason it was way oversize.  Haven't had this problem before.
Opened Mach3 Plasma and it filled the monitor screen normally.

How can I correct this?   ???

Thanks

Hager

Title: Re: Mach3 View Screen too BIG for my monitor
Post by: Hood on January 01, 2009, 04:02:13 PM

Go to Config menu then General Config and check the Auto  Screen Enlarge option, it will shring your screen to fit your monitor.
Hood

Title: Re: Mach3 View Screen too BIG for my monitor
Post by: Mr.Chips on January 01, 2009, 04:28:44 PM

I found the General Config and checkwd the Auto  Screen Enlarge option, however even if I move that screen to the very top I can only see a portion of the OK.  Tried clicking that but it doesn't resize the screen, is there something below the "OK" on the screen that I would need to click on but cannot see?

Title: Re: Mach3 View Screen too BIG for my monitor
Post by: Mr.Chips on January 01, 2009, 04:30:29 PM

OK I got it.

Had to shut down Mach and restart then it was OK

Thanks.

Title: Re: Mach3 View Screen too BIG for my monitor
Post by: Hood on January 01, 2009, 04:31:40 PM

you need top restart Mach after you have done the Auto Screen enlarge.
Hood

Title: Re: Mach3 View Screen too BIG for my monitor
Post by: Hood on January 01, 2009, 04:32:06 PM

ah you got it while I was typing :)
Hood

Title: Re: Mach3 View Screen too BIG for my monitor
Post by: Mr.Chips on January 01, 2009, 04:34:05 PM

Thanks Hood,  I'm back in the game now.

Hager Hay