Machsupport Forum

G-Code, CAD, and CAM => LazyCam (Beta) => Topic started by: Psad on July 15, 2006, 11:40:54 AM

Title: New problem
Post by: Psad on July 15, 2006, 11:40:54 AM

Attached is my .Tap file (very simple) Gcode cause it to cut inside instead of outside.  What am i doing wrong.

Title: Re: New problem
Post by: Brian Barker on July 15, 2006, 12:49:05 PM

will it work if you change the G41 to a 42?

Title: Re: New problem
Post by: Popeye on July 16, 2006, 04:52:57 AM

Hi,

I have a similar problem but only on the outside chain. See attached example (I've tested an other part but the result is the same)

Jean-Louis

Title: Re: New problem
Post by: Brian Barker on July 16, 2006, 10:54:40 AM

I think there is a problem with the Comp (G42 or G41) that is getting called :( This is not a simple problem and will take some time to fix.
Thank you
Brian