If GetOemLED(821) Then                      'Bar end signal
	Code "G0 G54 Z110"                  'Clear to make space for Bar fedder to push remnant out 
	ResetOutBit(90,11)                  'Collet close reset
	SetOutBit(90,9)                     'Collet Open
        SetOutBit(90,6)                     'Collet Open
        SetUserLed(1001,1)                  'Set Collet open LED ON
        If GetInBit(90,17) = False Then     'Wait for Start signal from Bar fedder                    
                Sleep(50)
        End If
        Code "G0 G54 Z-35"                  'Position stopper at top cut position 
                Sleep 1000
        If GetInBit(90,17) = False Then     'Wait for Start signal from Bar fedder                    
                Sleep(50)
        End 
        ResetOutBit(90,9)                   'Reset Collet Open
        ResetOutBit(90,6)                   'Reset Collet Open
        SetOutBit(90,11)                    'Collet Close
        Sleep 100
        SetUserLed(1001,0)                  'Set Collet open LED OFF
        Sleep 2000
        
                
Else
	ResetOutBit(90,11)                  'Collet close reset
	sleep 100
	SetOutBit(90,9)                     'Collet Open
        SetOutBit(90,6)                     'Collet Open
        SetUserLed(1001,1)                  'Set Collet open LED ON
        If GetInBit(90,17) = False Then     'Wait for Start signal from Bar fedder
                Sleep(50)
        End If        
        ResetOutBit(90,9)                   'Reset Collet Open
        ResetOutBit(90,6)                   'Reset Collet Open
        SetOutBit(90,11)                    'Collet Close
        sleep 100
        SetUserLed(1001,0)                  'Set Collet open LED OFF
        Sleep 2000

End If