     NEW VERSION !   >> MACH3 PLUGIN MODE ! << 

Instalation :
Just copy exe file into directory you would like to run it from. 
If you use it as Mach3Plugin - just copy dll file into Mach3 PlugIns directory,
run Mach3 and allow this plugin in Mach3 menu. Restart Mach3. 
It should be available in Mach3 Plugins menu then. The X and Y axe positions 
as well as camera picture ( if you have any ) will be catch and transferred  
to HappyExcellonToGCode program.

Remark : Camera video is tested with WinXP version only !
 ( let me know by e-mail if it works or not on diferrent versions  too )

If you consider to buy full version without freeware limitations, please 
send e-mail request to address lura@lura.sk . 
You can find more information as well as pricing on our web pages

                                    www.lura.sk.


Tips :

- all position and output file units are in .XX mm format
- work area is 300x300 mm ( dont try to load biger one ) 
          howewer its limited in freeware to 120x120mm
- always use positive coords 
- place your designs near to coords origin into 1.st quadrant in CAD
- generate Excellon file from CAD with options :
         - use absolute coords system !
         - keep leading and trailing zeros !
         - use 4.2 / mm number format ( 2.3 / inch otionaly - it will be converted into mm  ) 

1, Load input file 
2, Place board into machine
3, Position machine into Red and Green points manualy and enter coords into edit fields
4, Press GO ! button and wait for calculation ( it usually takes couple of seconds )
5, Load generated GCode file into machine
6, Run machine with disabled Z axe, just to check if positionning is OK
7, Switch on driller and axe Z 
8, Drill
9, E-mail me back your result report :-)

                                                            developer (at) lura (dot) sk