Installation instructions:

Copy "G96G95Patch.dll" to mach3 plugins directory
Copy "1024_mod1.lset" to mach3 directory
Copy "M95.M1s" to "Mach3/macros/mach3turn" directory 

Go to General Settings in Mach3 and check then "Ignore M codes while loading"
and uncheck "Lock rapid FRO to feed FRO"

test with sample program. "test.tap"


comments:

currently only work in MM mode.
Not working with plugins have enabled external override. If your plugins have config to external override set to DRO 1215


Plugin get pulley min and max settings and also get "G48 Sxxxx" for calculate maximum spindle speed.
To change feedrate in mm/rev program "M95 P#.###" 

This is an alpha stage plugin. 
please report bugs to: atrex66@gmail.com