Note: All settings not listed here were left in their original states.

Config - Native units
	MMs

Config - Ports and Pins
Tabs:
	Port Setup and Axis Selection
		Port # 1
		ON
	Kernal Speed
		25000 Hz
	All others
		OFF
Motor Outputs
Signal 	Enabled	Step Pin	DirPin	Low Act	SLA	SP	 DP
X Axis 	ON 	3 	2 	ON 	ON 	1	1
Y Axis 	ON 	5 	4 	OFF 	ON 	1 	1
Z Axis 	ON 	7	6 	ON 	ON 	1 	1
Input Signals
Signal	Enabled	Port#	Pin#	Act Low	Emulated	HotKey
XHome	ON	1	13	ON	OFF	0
YHome	ON	1	12	ON	OFF	0
ZHome	ON	1	10	ON	OFF	0
EStop	ON	1	11	OFF	OFF	0
Output Signals
Signal	Enabled	Port#	Pin #	Act	Low
Output #	1	ON	1	1	OFF	Motor
Output #	2	ON	14	1	OFF	Coolant
Spindle Setup
Relay Control
OFF	Disable Spindle Relays
Clockwise (M3)	Output #	1
CCW (M4)	Output #	1

Config - Motor turning X, Y, Z axis:
	Steps Per	266.66666
	Velocity	2000		(it looked OK at 2500 but it needs more testing) 
	Acceleration	100

Config – Homing limits
	Reversed	Soft max	Soft min	slow zone	home off	home neg	auto zero	speed
X	off	100	-100	1	0	on	on	50%
Y	off	100	-100	1	0	on	on	50%
Z	off	100	-100	1	0	on	on	50%

Notes:
Setting Homing limits>auto zero=off 
Shows the cumulative step errors when the machine is sent to ‘Ref Home’.
It’s useful for testing the ‘Motor Turning’ parameters.

For bigger machines the Motor Turning Velocity will probably need to be reduced.

??

??

??

??

Configuration of Mach3 for a Heiz CNC HIGH-Z s-400