ReadMe1st

What the plug in does is watch directly these Signals
so you dont have to use a: "Brain", or "Macropump" or
other VB device to map these signals to a Screen LED
that represents that Signal. The Screenset called:
"1024 TestIO.set"  is the standard OEM Mach Mill Screen
with ALL the standard Input/Output signals on the redone
Diagnostics page.

Below is a list of the User LEDs that the Plug in uses
If you want to use this plug in and screen set
then you will need to check to make sure that your Wizards,
screens, or other items are not ALSO using these.

The Plug in will "tie in" LEDs for the Standard
Input and Output Signals under Ports and pins for:

Inputs: 
1).	OEMTrigger's 1-15

Outputs: 
1).	OUTPUT's 7-20
2).	Charge Pump, Charge Pump2, and Current Hi/Low

ULED's Used for Input Signals are:
1).	 1301-15 is used for OEM trigs 1-15
 
ULED's Used for Output Signals are:
1). 	1316-32 is used for Outputs 7-15,Charge Pump,
	Charge Pump2 and Current Hi/Low

Scott