4381
Show"N"Tell ( Your Machines) / Re: The Laser Project.
« on: April 01, 2015, 08:35:28 AM »
A bit of experimentation here…
It is not possible to cut soda-lime glass with a CO2 laser but, some while back, I read a couple of patents which cover a ‘fracture technique’ where the laser is used to heat the glass (causing compressive stress) and then the glass is cooled (causing tensile stress) which in turn creates a fracture along the defined toolpath.
Obviously I have much to learn here but needing 2 x 20mm diameter, opaque glass, discs I thought this process may be worth a try.
I found that straight line fractures are relatively easy to achieve but circular fractures needed a bit more thought.
On my first attempt I found it impossible to remove the discs so using slightly more power on the second run I created radial fractures in all directions and I now have the two required discs which fit the intended application perfectly. The edge quality is not that good (but that is unimportant for my application) although I think refining the technique will lead to better quality results.
Just thought I would share the info for any others that may be interested in experimenting with laser glass cutting.
Tweakie.
It is not possible to cut soda-lime glass with a CO2 laser but, some while back, I read a couple of patents which cover a ‘fracture technique’ where the laser is used to heat the glass (causing compressive stress) and then the glass is cooled (causing tensile stress) which in turn creates a fracture along the defined toolpath.
Obviously I have much to learn here but needing 2 x 20mm diameter, opaque glass, discs I thought this process may be worth a try.
I found that straight line fractures are relatively easy to achieve but circular fractures needed a bit more thought.
On my first attempt I found it impossible to remove the discs so using slightly more power on the second run I created radial fractures in all directions and I now have the two required discs which fit the intended application perfectly. The edge quality is not that good (but that is unimportant for my application) although I think refining the technique will lead to better quality results.
Just thought I would share the info for any others that may be interested in experimenting with laser glass cutting.
Tweakie.