6551
General Mach Discussion / Re: Reference not stopping
« on: September 25, 2017, 12:05:36 AM »
Hi Christoph,
may be a way around this is to disable ALL inputs and outputs on the NCpod config page and then
work with just one input until you've got it sorted. Then choose one output and work on that.
The outputs for the motors are fixed and labeled, you are using those I presume?
may be a way around this is to disable ALL inputs and outputs on the NCpod config page and then
work with just one input until you've got it sorted. Then choose one output and work on that.
The outputs for the motors are fixed and labeled, you are using those I presume?