11321
General Mach Discussion / Re: Zeroing Z
« on: July 01, 2011, 09:34:42 AM »
Maybe I am not understanding but instead of SetVar why not just DoOEMButton (1008), (1009) etc?
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Also, there has been a bug with the G Code window for a long time. I don't know if it has been fixed in later versions but the way to test it is to feed hold while running a G Code and then press Edit G Code. I realize it's not something you would normally do, but you can forget it's only in feed hold and not stop if you're looking for an error in the G Code. The last time the bug occurred I had only scrolled down in the G Code window and then wanted to change something in the code. The bug produces a never ending cycle of error messages until it locks up the computer. This is in Mach 3 Turn ( several versions ).
Regards, Glen.