3211
FAQs / Re: OK, I'm stumped!!
« on: December 03, 2016, 02:11:52 AM »
In Windows Device Manager check the address (first value in I/O Range) of the LPT parallel port. Check that you have this address entered in Mach3 (Config. / Ports & Pins) as Port 1 and that it is enabled.
(Don't place too much faith in the Port 1 Pins Current State indicator - it does not always work as intended).
Tweakie.
(Don't place too much faith in the Port 1 Pins Current State indicator - it does not always work as intended).
Tweakie.