11150
« on: July 26, 2011, 09:18:36 AM »
aoak had a look at the xml and they seem reasonab ly consistent, few differences but axis and homes seem the same.
I do not use and have never used the standard lathe screenset so it could well be that that is causing issues. I have just looked at the OEM codes for the Home buttons in it and they are specific to Turn.
I made my screen up with standard buttons rather than Turn specific ones, might be worth your while copying the 1024.set to a different location, rename it to Lathe.lset and then place it back in the Mach folder. You could then load it from Turn and you would have a familiar layout to mess about with.
Maybe the Turn manual has details on the way the buttons work, never read it so dont realy know but must be worth a look.
Now I know there are issues with SoftLimits in Turn so best switch them off at this time.
Hood