4701
Post Processors / Re: Solidcam 2006 Rev10 to mach2-mach3 post pro
« on: July 11, 2014, 04:28:12 AM »
Well spotted bscandanavia, thanks for posting the details.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Does the Mach3 driver have to be disabled or removed?
I was able to install and see the plugin and driver in the Mach4Hobby directory. When I run plugin configuration in Mach4 or the DarwinTest.exe from the zip directory and use the same port as my running Mach3, none of feedback that's shown in video happens. I select the same port, I enable it, I answer the prompt, and then try toggling any of the limit switches, probes, or estop and none of the leds toggle on the screen.