Hood
I apologize and of course you are correct, I meant to say the as looking from above, the machine homes to the upper left. Having said that and from your comments, at least I know the axis's are running in the proper direction as I was concerned that when I auto set the limit switches in the setup that I may have effected travel direction due to my inability to determine pos or neg direction.
If I am understanding you correctly, it would not make any difference where on the machine I homed it, I just have to input the total travel distance from the HOME position to the end of my machines travel.
Lastly I am not sure where the input is located for the "HOME OFF" in the software, that may be the culprit for me.
Thanks
Ken