Hello all,
I have been talking with Bob Campbell, My main concern of the THC300 he sells is that if it needed to touch off the material every time it needed to make a peirce, it would be very time consuming. He told be that with Sheetcam you can post the gcode, so that it only touches off the material every time it needs to peirce as long is away from the last time you peirced a set distance you tell it to.
So if you set that distance to say, 12 inches, then if there are 17 peirces within that 12 inches, then it only needs to touch off once. instead of every time.
Can Lazycam do that?
Best Regards
Fernando