4721
Galil / Re: Galil Plugin is awesome!
« on: July 02, 2014, 02:21:11 AM »
Excellent tip Rational1 - thanks for sharing the info.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
there still problem with different g code , i try 2.200.000 g code and run from here start at line 1.000.000, and problem again only begin at 550.000, but if i try from line 545.000 it will run
My mill has the input for a USB cable from the computer and it goes into where the manual control pendent plugs into also. Is this the motion controller that you are speaking of?