2801
General Mach Discussion / Re: UC300 quits after 500 lines
« on: April 20, 2017, 04:39:33 AM »
You need a Mach3 license to run more than 500 lines of Gcode.
(you will be able to see and run all the Gcode in simulation mode but you will not be able to output more than 500 lines of Gcode to a machine).
http://www.machsupport.com/shop/mach3/
Tweakie.
(you will be able to see and run all the Gcode in simulation mode but you will not be able to output more than 500 lines of Gcode to a machine).
http://www.machsupport.com/shop/mach3/
Tweakie.