23951
General Mach Discussion / Re: So Close to it working!
« on: January 08, 2008, 02:08:29 AM »
rene
Sounds like you may have the pins asigned wrong for the X axis, either that or you have the motor wiring wrong, one other thing to try is change the Dir Low Active setting for that axis as seemingly some drives can be picky about it.
When your Y axis doesnt change to zero is this definitely not zero if you toggle the Machine Coords button. If its still not zero on machine coords then make sure you have it set to Auto Zero in the Homing and limits page.
Hood
Sounds like you may have the pins asigned wrong for the X axis, either that or you have the motor wiring wrong, one other thing to try is change the Dir Low Active setting for that axis as seemingly some drives can be picky about it.
When your Y axis doesnt change to zero is this definitely not zero if you toggle the Machine Coords button. If its still not zero on machine coords then make sure you have it set to Auto Zero in the Homing and limits page.
Hood