321
General Mach Discussion / Re: Mach 3 on Tormach laser is not proceeding past M3
« on: February 06, 2022, 04:55:30 PM »
Because of the delays associated with the M3/M5 commands and the high speed requirements for laser switching operations, many years back, Artsoft introduced the M11Px/M10Px command set for use with Mach3 and M62Px/M63Px for use with Mach4. Whilst not all motion controllers support these commands there are alternative methods that can be used to overcome the M3/M5 delays.
It is overlong but this thread may be of interest to you; https://www.machsupport.com/forum/index.php?topic=12444.msg265104#msg265104
Tweakie.
It is overlong but this thread may be of interest to you; https://www.machsupport.com/forum/index.php?topic=12444.msg265104#msg265104
Tweakie.