3058
« on: October 09, 2013, 07:59:51 PM »
I can't imagine that this has anything to do with g-code.
What version of Mach3 are you using?
Are you using the parallel port?
Is this repeatable with specific g-code? If so, can you post it?
The g-code you posted runs fine here.
One thing that I recommend. If you run into any type of issue where you stop a macro while it's executing, like in your example above. Close and restart Mach3 before doing anything else, as there's a good chance that macros will no longer execute properly.
Is it possible that you had stopped the auto zero during execution prior to having the problem you're seeing?
For some reason, it appears that mach3 is hanging during the macro?
I don't recall any of the other users of my screenset having this or similar issues. The only thing I can recommend at this time is completely removing Mach3 and re-installing.