I'm setting up my new machine (A Zen Toolworks Plastic-frame CNC), and I wanted to set up 0,0 in the upper left corner, and have what's displayed in the preview window cut out with the same orientation. However, I'm having a nightmare trying to set up the Y axis. I've tried every combination of 'Dir Low Active', and on the motor home/soft limits screen, 'Reversed', and 'Home Neg', and I haven't been able to configure it right. What I want to do is have it home right, move properly when I jog it (Yes, the Y will move opposite, but correct relative to the cutter), and have the DRO numbers move in the positive direction when moving away from 0,0. Is there a setting I'm missing? Am I going about all this wrong?