3801
Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!
« on: February 19, 2016, 02:19:55 AM »I've decided to make the move to Mach3, and I'm already a little frustrated. I can fire up Mach2, go to the Motor tuning page, and all is good. I got to mach3, where I have enabled the lpt1 port, and then to the motor tuning page, and I can't get a motor to move. So I guess this is an intro, and a plead for help.. I've watched a few intros, and thought I'd read the manual, but..... here I am... lost...
Welcome to the forum.
If you post your question as a New Topic I am sure it will get many answers / suggestions as to resolving the problem.
Could be that the Ports and Pins (Step and Direction) are not set correctly or that one or more enable signals are required.
Tweakie.