1
General Mach Discussion / Re: Getting Outputs from Mach3
« on: January 31, 2013, 02:36:06 PM »
Hi Hood
I appreciate that there is more than one way to write code but
as you have a lot of experience and I have very little I knew your code was
likely to be better than mine , but I wondered why it was better.
I sat looking at it trying to see what it did differently to mine , and then I
spotted it. My code will show the increment size and the jog mode which
is what I required but of course when you are in continuous jpg mode then
increment size is irrelevent. Your code turns off the increment size LEDS when
in continuous jog but mine still showed the jog increment which is pointless
So thank you for the new code, which I will now use , but even more thank you for
the learning experience . I now know a little bit more than I did before.
Don
I appreciate that there is more than one way to write code but
as you have a lot of experience and I have very little I knew your code was
likely to be better than mine , but I wondered why it was better.
I sat looking at it trying to see what it did differently to mine , and then I
spotted it. My code will show the increment size and the jog mode which
is what I required but of course when you are in continuous jpg mode then
increment size is irrelevent. Your code turns off the increment size LEDS when
in continuous jog but mine still showed the jog increment which is pointless
So thank you for the new code, which I will now use , but even more thank you for
the learning experience . I now know a little bit more than I did before.
Don