4171
LazyCam (Beta) / Re: Importing a Cabinet Parts Pro DXF
« on: June 22, 2011, 07:01:36 PM »
Knowing what it was ignoring would help. The .dxf looks OK in AutoCAD, but I don't use LazyCAM
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hi Ger,
I'll check those settings, If it turn CV mode off completely the machine is very "steppy" (each line of code has a slight pause before the next begins, which is slow on the engraving as there are so many lines of code!)