1401
General Mach Discussion / Re: moveing z axis up and down
« on: October 06, 2007, 03:42:19 PM »
Hi, Brian
There are several boards that will do that for small steppers.
If you have a stepper control box you can use a 555 timer with a var. pot/resistor for puls/speed and control dir with 5 volt's.
Can you Fix LC latest ver. Arc Errors ?.
Thanks, Chip
There are several boards that will do that for small steppers.
If you have a stepper control box you can use a 555 timer with a var. pot/resistor for puls/speed and control dir with 5 volt's.
Can you Fix LC latest ver. Arc Errors ?.
Thanks, Chip