Messages

2361

Newfangled Solutions Mach3 Wizards / Re: Cut Gears alteration

« on: August 23, 2006, 05:38:17 PM »

John I will look into this asap I will have the code open to see if it is posable to add the gear hob stuff...

2362

LazyCam (Beta) / Re: lazycam

« on: August 23, 2006, 03:21:04 PM »

Very Good! You are going to have this running the water jet in no time!

Keep up the good work
Brian

2363

Mach Screens / Re: Toolpath Colour Change

« on: August 23, 2006, 06:00:55 AM »

There is a setting for the color under the toolpath config.
Yyou can set rgb to a value 0-1

Hope that helps

2364

Newfangled Solutions Mach3 Wizards / Re: Cut Gears alteration

« on: August 23, 2006, 05:58:44 AM »

Sorry I think I lost the list that I had this on.. It is back on the list and will get fixed! If you everneed something and I have not done it please feel free to ask me a few times. I work on so many things that some times the little ones get lost

Thank you

2365

LazyCam (Beta) / Re: lazycam

« on: August 23, 2006, 05:54:28 AM »

Sorry about that  I was working on the code and didn't setup the mill post.. .625 should work for you and if you guys are happy I will have it added to the download of Mach3

Thanks

2366

General Mach Discussion / Re: How to get same results with different computer speeds

« on: August 23, 2006, 05:51:09 AM »

the speed of the computer should have no effect on the programs that you are running ... are you talking about the motor tuning settings? If so you can copy over the XML and you are ready to go

2367

General Mach Discussion / Re: Setup estop, spindle on/off, and Xylotex 3 axis drive

« on: August 23, 2006, 05:48:57 AM »

You need to get a break out board   This will stop the pins from flashing the output on startup. This is done by the chargepump... it is a 12Khz signal that is used to tell if the control is in a good state. http://cnc4pc.com/Safety_Charge_Pump.htm This should fix the problem

2368

Newfangled Solutions Mach3 Wizards / Re: NewFangled Screen Size

« on: August 21, 2006, 10:19:52 PM »

I will have a look at it... thanks

2369

Newfangled Solutions Mach3 Wizards / Re: Wizard Update Notifications?

« on: August 21, 2006, 11:18:14 AM »

The NFS wizards are third party software.. so yes it is an other license file that you must got

And I have not heard of cut rectangle doing that... could you please tell me what you are entering for data and what Rev number you are running?

Thanks
Brian

2370

General Mach Discussion / Re: Tool measure macro

« on: August 21, 2006, 11:15:27 AM »

Thank you for posting it