Messages

2181

General Mach Discussion / Re: Retrofit/Upgrade

« on: September 22, 2006, 07:19:03 AM »

IT can be done but the hard part is going to be writign the code for the toolchanger and so on... And you would need to have a PLC to get you the IO that you need for the toolchanger. Othere then that it is about the same as doing ay other lathe.

2182

General Mach Discussion / Re: Screen display when maximised?

« on: September 21, 2006, 10:11:40 PM »

That is odd.. I have never had a problem like that

2183

General Mach Discussion / Re: setting up coolant pins

« on: September 21, 2006, 10:10:35 PM »

So are you seeing the pin change state ? If not what are the settings that you are using on the pin.
Thanks

2184

General Mach Discussion / Re: Softlimits

« on: September 21, 2006, 09:01:01 PM »

After testing for an hour I can't see a problem The only thing that I can that may be a problem is the G91 G28 Z0.0 ... I would like you to try changing them to G0 G53 Z0.0 It will do the same thing...

Could you get me a smaller test file that gives you trouble? Long files are a bitch... I spend hours watching the screen


Thanks
Brian

2185

LazyCam (Beta) / Re: new video

« on: September 21, 2006, 07:34:14 PM »

No other video's have been changed at this time.

That was a good question

2186

General Mach Discussion / Re: M5 Spindle Does Not Stop

« on: September 21, 2006, 07:29:26 PM »

There should be  DoSpinStop() in the M5 macro. could you please check it

Thanks
Brian

2187

General Mach Discussion / Re: max nc 10 wave drive

« on: September 21, 2006, 07:27:58 PM »

please post your MXL and I will check your settings

2188

General Mach Discussion / Re: MAXNC10CL and MACH3 issues

« on: September 21, 2006, 07:25:14 PM »

Yup if you post it i will have a look at it too

2189

General Mach Discussion / Re: 4 axis not work

« on: September 21, 2006, 07:21:08 PM »

Check to see what the port address is under device manager

2190

General Mach Discussion / Re: encoders

« on: September 20, 2006, 10:33:11 PM »

That should work fine

There are a few people that are doing this and I think that is about the encoder count that they are running...


Thanks
Brian