5241
Show"N"Tell ( Your Machines) / Re: Chiron FZ12 on its way sometime soon(ish)
« on: April 28, 2013, 12:50:29 PM »
Been doing a bit of tidying as the workshop has been much more of a mess than its normal mess
Space is limited but I wanted to get something set up as close as possible to the control panel and height setter as I could for the collet holders. I made up a plate out of some 10mm steel plate I had and have enough storage for 8 tool holders plus one place that has dogs welded so I can loosen/tighten collets, it doesnt take up too much room and should work out well. Will paint it later as I still have a few bits and pieces to paint but will wait until everything is ready so that I dont have to mess with mixing the two pack paint a few times.
Hood
Space is limited but I wanted to get something set up as close as possible to the control panel and height setter as I could for the collet holders. I made up a plate out of some 10mm steel plate I had and have enough storage for 8 tool holders plus one place that has dogs welded so I can loosen/tighten collets, it doesnt take up too much room and should work out well. Will paint it later as I still have a few bits and pieces to paint but will wait until everything is ready so that I dont have to mess with mixing the two pack paint a few times.
Hood