16281
General Mach Discussion / Re: Mach 3 and Burny 3
« on: March 06, 2010, 04:12:59 PM »
I am 99% certain the servo drives will be analogue input so you would need to convert the step/dir from Mach to analogue to use them.
Something like the DSPMC or Kflop would be needed for that, also there is a board called the YAPSC that can do it but not sure how well it works.
Hood
Something like the DSPMC or Kflop would be needed for that, also there is a board called the YAPSC that can do it but not sure how well it works.
Hood