Messages

2891

LazyCam (Beta) / Re: LazyCam won't load

« on: May 30, 2006, 02:07:23 PM »

There will be a new Rev soon becuase C++ seemed to have an error when it bult the version that is out now I will look to see if I can find where the problem cam from .. Thank you and sorry about this..
Brian

2892

LazyCam (Beta) / Re: LazyCam won't load

« on: May 30, 2006, 06:58:30 AM »

Can you see the LazyCam.EXE in the mach3 directory?

2893

Mach SDK plugin questions and answers. / Re: New SDK plugin development forum.

« on: May 29, 2006, 09:52:24 PM »

O Boy this one is going to be fun to support   Hope there are a few  Cprogramers out looking for some fun

2894

General Mach Discussion / Re: What Resolution

« on: May 29, 2006, 11:44:04 AM »

About a 2:1 Drive should get you about the best settings...

2895

General Mach Discussion / Re: Mach 3 setting up

« on: May 28, 2006, 11:40:30 PM »

Mach3 has MUCH less bugs in it than Mach2...
Hope that helps
Brian

2896

General Mach Discussion / Re: Testing Mach3 with difficulties

« on: May 28, 2006, 10:30:05 PM »

Try taking the M3 out of the Gcode file. I think that you are having a problem with the M3 Dwell...

2897

Newfangled Solutions Mach3 Wizards / Re: Need VB Terms explanation

« on: May 28, 2006, 06:13:57 PM »

Deon this is to format the number that is going to be output... So nFmt(X +2 /y,4), this will do the cals to figure out what the point will be and then it will output the number as follows 0.0000

Hope that helps
Brian

2898

General Mach Discussion / Re: Speed, Size, New and need help

« on: May 28, 2006, 06:11:18 PM »

Hello,
 It is Good to hear that you are having a good time with Mach3!
The Units can be tested by jogging the Axis and seeing if it move the correct amount. If it is not right than you should redo your motor settings... The Pulses per unit is what you will need to adjust..

The Feedrate of the files that you are cutting can be changed by setting the F code in the file that you are running. So if you see an F10 change it to F40 and you will get a faster cut rate.


Thank you and have a good time !
Brian

2899

Mach3 and G-Rex / Re: I'm ready are you! I/O Questions.

« on: May 28, 2006, 07:23:58 AM »

I have not done any analog I/O on the Grex

2900

LazyCam (Beta) / Re: Understanding LC settings

« on: May 28, 2006, 07:20:50 AM »

I think I am going to have to do the video Today! I will do it and get it online tonight!

Thank you and is it okay if I use your file?