Messages

1381

General Mach Discussion / Re: Timer Variations

« on: March 30, 2007, 02:46:45 PM »

I see

I know they are working on it and they will not release till they are happy with how it works.

1382

General Mach Discussion / Re: Rutex and Mach3 problem

« on: March 30, 2007, 02:44:06 PM »

Sounds to me like that board is not working at all... I have never used them so i am no help...
I talked to Dave from CNCTeknix and you can use there cpu board to run a +/-10v amp. I talked to Stig and he will be ordering some drives to have them here in the states and I could get one for you if you like.

1383

LazyCam (Beta) / Re: Lazy Cam Pro

« on: March 29, 2007, 03:14:54 PM »

I will have to do that after I am done with the A axis stuff... I have done so much that Lathe will not work at this point. This should be one of the last big things that I have to add (I hope).

Thank you for the feedback Chip
Brian
 

1384

LazyCam (Beta) / Re: Lazy Cam Pro License Not Working With Mach3 Licensed Version R2.0.061

« on: March 29, 2007, 09:13:00 AM »

Could you set up on the C: drive and tell me if it works?
thanks
Brian

1385

LazyCam (Beta) / Re: Lazy Cam Pro

« on: March 29, 2007, 09:11:58 AM »

Go to the ports and pins page and tell it to revers the Arcs and it should work for you

1386

LazyCam (Beta) / Re: Confused about LCAM versions

« on: March 29, 2007, 09:10:37 AM »

You are correct and the Revs will increment up from the 2.00.060 rev

1387

LazyCam (Beta) / Re: Optimization doesn't seem to be working.

« on: March 29, 2007, 09:06:35 AM »

Okay, I have my Lcam all messed up at this point from adding an other axis   so after I get my copy so it will run again I will check the file that you posted and try to find the problem.

thanks
Brian
 

1388

LazyCam (Beta) / Re: LCAM V.2.66 download

« on: March 29, 2007, 09:03:52 AM »

The Rev on the webpage is up to date ... I don't think Art changed the date by the link

1389

LazyCam (Beta) / Re: Mach3 Ver. 2.0.060 and NEW LCAM

« on: March 29, 2007, 09:02:10 AM »

You need to enter the too Rad. IT is a bug and i will fix it for the next release

1390

General Mach Discussion / Re: Rutex and Mach3 problem

« on: March 29, 2007, 08:57:31 AM »

Tell us if the ground gets your motor running