1
dspMC/IP Motion Controller / Re: Dspmc Encoders not in sync with mach 3
« on: October 05, 2014, 08:26:00 PM »
Thanks I will check the encoder thing out. I have much error in repeatability also.we are considering new encoders also.mine are EMC 755 HV 1250ppr.Quad ,A,B,Z 5 volt and Grnd, 8 wire. seem like good encoders.anyone know about these encoder good or bad? I have the grounded to COMM.is that bad? seem much more stable than hooked to the 0v line.
On Mine under settings the DRO's do not move,are they suppose to move?the crosshars on the program run screen are not following the tool path.under program run it seems to read the G code,X,Y,Z even feeds and rapids.it does not read the actual coordinate move amount. a circle will come out 30% larger than it is suppose to come out. we are set at 51020 pp/unit.
On Mine under settings the DRO's do not move,are they suppose to move?the crosshars on the program run screen are not following the tool path.under program run it seems to read the G code,X,Y,Z even feeds and rapids.it does not read the actual coordinate move amount. a circle will come out 30% larger than it is suppose to come out. we are set at 51020 pp/unit.