Messages

1

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: January 03, 2019, 09:53:00 PM »

Hello, newbie here. I am using Mach4 with a PMDX motion controller, have the machine setup and moving but the steppers jog real real slow. I have looked at the motor tuning page but I cannot enter any values in the grayed out boxes for speed.
In the jogging tab, the jog rate is set at 100% but the motors turn so slow the gantry barely moves.
Hope it is something simple that I am missing...??

Thanks for any help here.