7921
General Mach Discussion / Re: Will Mach3 Work with this?
« on: September 06, 2010, 07:11:18 AM »
Hi Rikk,
Having read the info on their website I think this controller is primarily intended for their own software and I think you would be struggling to try and get this to work with Mach.
Their machine conversion kits look excellent so why not use their conversion parts but fit Gecko's for the machine control. These work really well with Mach and have good backup service if required.
Just a thought.
Tweakie.
Having read the info on their website I think this controller is primarily intended for their own software and I think you would be struggling to try and get this to work with Mach.
Their machine conversion kits look excellent so why not use their conversion parts but fit Gecko's for the machine control. These work really well with Mach and have good backup service if required.
Just a thought.
Tweakie.