21
General Mach Discussion / Mach3 USB Homing
« on: August 31, 2018, 06:42:21 AM »
Hello
I have a Mach3 USB board as in the attached picture.
I'm having trouble getting the 3 axis back to their home position. I started with just the x- axis. Home position is indicated by active low limit switches. The signal wire from the limit switch was fed into Input pin 3. Can you please help me with the pin and port configuration for this, or if there is something else that needs to be done as well, please do let me know.
Thank You
I have a Mach3 USB board as in the attached picture.
I'm having trouble getting the 3 axis back to their home position. I started with just the x- axis. Home position is indicated by active low limit switches. The signal wire from the limit switch was fed into Input pin 3. Can you please help me with the pin and port configuration for this, or if there is something else that needs to be done as well, please do let me know.
Thank You