5361
General Mach Discussion / Re: Newbie with TB6560 1st time testing problems
« on: March 26, 2013, 06:34:31 AM »
As an update to my earlier post…
It is the actual pin numbers you are trying to find – If the pin number entered in Enable 1 does not lock the X axis motor (or any other motor) there is little point in trying that same pin number in any other Enable. Just move on to the next pin number.
Tweakie.
It is the actual pin numbers you are trying to find – If the pin number entered in Enable 1 does not lock the X axis motor (or any other motor) there is little point in trying that same pin number in any other Enable. Just move on to the next pin number.
Tweakie.