Hi all,
I have mach3 with a NVEM motion control on a home built plasma table.
motion is good and calibrated.
single stepping works but when I run G code the M3 plasma start command executes before the previous move finishes, stopping before end of cut.
If I then rapid to another cut the plasma restarts during the rapid.
stepping the code runs as expected.
I get the same problem with any G code source it seems.
The start and stop are shown on the toolpath in the incorrect places also.
I get the same result with moving the torch signal to he flood output and editing the Gcode M3 M5 to M8 and M9
It is not plasma noise I get the same result with a lamp on the plasma drive.
Has anyone experienced this or got a solution please.
Regards
Bob