5321
General Mach Discussion / Re: Input pin help
« on: April 12, 2013, 11:41:06 AM »
Hi Ricey3,
The digitize LED should only illuminate when the touch plate (pin 13 in your case) is connected to GND.
Here are a couple of things you may like to check again...
Check that you have pin 13 enabled and configured for active low.
Check that you do not have pin 13 configured elsewhere in your setup (causing a conflict).
Check that the GND connection you are using is the same GND that the Breakout board uses.
Hope this helps.
Tweakie.
The digitize LED should only illuminate when the touch plate (pin 13 in your case) is connected to GND.
Here are a couple of things you may like to check again...
Check that you have pin 13 enabled and configured for active low.
Check that you do not have pin 13 configured elsewhere in your setup (causing a conflict).
Check that the GND connection you are using is the same GND that the Breakout board uses.
Hope this helps.
Tweakie.