23491
General Mach Discussion / Re: mach don't control the spindle switch
« on: March 27, 2008, 03:59:07 PM »
I would think the reason the relay is not working is because Bec's Mach is set to MaxCL mode. I do not know a lot about this mode as I have never used it but from what I understand it is used to interface Mach to MaxNC hardware. When any of the MaxNC modes are chosen the pins are asigned by Mach to conform to MaxNC hardware and can not be changed by the user.
If you could supply a pinout for your board then we should be able to advise how to get thisi machine up and running correctly and not using MaxCL mode. I do not know what pin 8 in MaxCL mode is asigned to but it certainly seems that it is not a user configurable option.
Hood
If you could supply a pinout for your board then we should be able to advise how to get thisi machine up and running correctly and not using MaxCL mode. I do not know what pin 8 in MaxCL mode is asigned to but it certainly seems that it is not a user configurable option.
Hood