22751
General Mach Discussion / Re: im service parrellel sys- 4 mach3 setup
« on: July 06, 2008, 07:28:09 PM »
What are the encoder lines? possibly 500ppr?
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Fantastic, hopefully this takes care of it. Do you think though that this setting is responsible for the tapered sides in my multi-pass parts, or is there another gremlin yet to be discovered? Thanks for everyone's help.
-tulsah