Messages

211

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: September 14, 2022, 12:29:22 PM »

I would start by reversing the direction in the homing and limits screen for X and Y axis.

Then ask any more questions you have in the General Mach Discussion.

https://www.machsupport.com/forum/index.php?board=1.0

212

General Mach Discussion / Re: PWM Spindle Speed off by a factor of 100

« on: September 14, 2022, 12:21:25 PM »

Have you set your pulley speeds

213

General Mach Discussion / Re: PWM Spindle Speed off by a factor of 100

« on: September 08, 2022, 06:56:38 PM »

Have you set the min and max values in the spindle pulley section and selected pulley 1

214

General Mach Discussion / Re: Mach3 Shows Drawing in wrong Quadrant

« on: August 26, 2022, 07:58:29 PM »

You need to post your probing code, it could be timing or parameter errors

215

General Mach Discussion / Re: Mach3 Shows Drawing in wrong Quadrant

« on: August 26, 2022, 09:07:46 AM »

You must have the  X & Y axis setup the wrong way round on your machine or you have mirroring turned on

216

General Mach Discussion / Re: Lathe calibration problems

« on: August 22, 2022, 09:38:50 AM »

If you enter G01 G91 Z-10. F50. the machine will move in incremental steps of 10mm.

217

General Mach Discussion / Re: Mach4 Stops at G98 G81 - No error

« on: August 18, 2022, 08:20:36 PM »

Line 118 has 2 G00 commands (G00 & G0)

Try putting the G98 on the line before the G81

Are you going to hit the Z- softlimit ?

218

General Mach Discussion / Re: Mach3 M6 for ATC requires a Cycle Start to continue after tool change

« on: August 10, 2022, 06:10:07 PM »

It Could be a setting in the 'General config'

219

General Mach Discussion / Re: Problem with Turning Maschine by G96

« on: August 10, 2022, 06:06:05 PM »

G50 S2000 before the G96 line will set the maximum spindle speed to 2000 RPM in G96 mode E.g.

G50 S1500 (max rpm set to 1500)
G00 X100. Z1. G96 S200 M3
G01 X-1. F.25
G00 X100.

220

General Mach Discussion / Re: Work offset changes if i press reset

« on: August 01, 2022, 09:00:44 AM »

What is in the fixture offset table before and after this happens?

Why are you using so many fixture offsets?

Can you post your gcode.