7161
General Mach Discussion / Re: After using the “Steps Per Unit” in “Axis Calibration” my CNC wont run properly
« on: September 03, 2008, 09:56:14 PM »
MrChips,
Change it to the 16227 as Ger 21 suggests
.986/1=16000/X its a ratio to find how much to increase your steps
.986X=16000
X=16000/.986 = 16227 that should very close and if not calculate it again ( probably not linear)
( Another way is to make a longer travel if you can measure it accurately, but the inch travel should surfice)
RICH
Change it to the 16227 as Ger 21 suggests
.986/1=16000/X its a ratio to find how much to increase your steps
.986X=16000
X=16000/.986 = 16227 that should very close and if not calculate it again ( probably not linear)
( Another way is to make a longer travel if you can measure it accurately, but the inch travel should surfice)
RICH